How to install the integral shower room?

1.Usually, all shower rooms are relatively independent Spaces, specially divided in the bathroom. Determine the direction of the shower room and shower equipment, pay attention to whether there is water distribution on the wall, and avoid using it when drilling;

2. Bottom basin of the device. Assemble the bottom birdbath and place it in the equipment location. After installation, some owners found pools and pools with standing water at the bottom. This is because the basin will tilt when installed. After installation, check that the basin is level according to the horizontal line. After adjusting the height of the bottom basin, connect the water pipe;

3. After installing the bottom basin device, carry out the drainage test. If there is water leakage or sewer blockage, please solve it in time and then proceed to the next treatment;

4. If the shower room is equipped with sliding doors, the track can be installed after the drainage test is correct. The lower guide rail shall be installed in the center of the stone foundation.

5. Aluminum alloy structure of the device. Clamp the debris into the upper and lower rail and lock the rail and debris with screws. Place the aluminum material near the wall into the remaining material on the left and right, and then place the assembled shower structure in the center of the stone base to adjust the horizontal orientation. Mark the location of the wall corresponding to the opening on the wall aluminum material, and then drill a hole at the mark with an electric drill. The size of the hole should be slightly larger than the diameter of the bolt, or the bolt should be driven into the hole. Finally, the aluminum alloy structure is locked on the stone base by fastening screws. Now many manufacturers in order to be beautiful, will be equipped with decorative cover fastening screws, after the installation of decorative cover overall style is more harmonious;

6. Fix the bottom plate and shower screen on the back of the bottom basin, and then fix the fixings on both sides with stainless steel screws.

7. Insert the seal strip into the gap between the glass and the frame on both sides and clamp the tempered?? Glass and lock it in the drilling direction of the bottom basin;

8. Install sliding doors and handles, assemble the top cover, and then seal the edges with glass glue;

9. Connect the hot and cold water pipes, drain the water, and check whether the water supply is normal;

10 Connect downspouts. Insert the pipe, seal around the pipe opening with glass glue, and test the water resistance again. If there are no leaks or clogs, the device is successful.